无后坐控爆拆除砖砌水塔的实践

介绍了对一砖砌水塔进行无后坐拆除爆破时爆破参数的选取,以及控制后坐的措施.实践证明:用控制爆破方法,选择合理的爆破参数完全可以控制水塔在倾倒时的后坐.     

单轴-平面W型复合锶铁氧体的制备及其吸波特性研究

用草酸盐共沉淀和微量掺杂法研制六角晶系W型Ni,Zn,Co,Al多元复合锶铁氧体，通过调节Ni2W同Co2W的摩尔比例，可使该种铁氧体易磁化方向从C单轴型向垂于C轴的平面型转化，控制置换锶铁氧体中部分Fe3 的微量掺杂Al3 ，可以调整4πMs值，提高磁晶各向异性场，测试分析了5种不同含Co量的W型复合锶铁氧体粉料涂层的吸波特性，发现其自然共振吸收峰随Co含量增加向低频方向偏移，最高吸收峰可达32．8dB，是适用于电子隐形技术的高品位的微波吸收剂。     

高可靠镀Ni／Au工艺及其在微波PTFE电路上的应用

介绍了高可靠电镀Ｎｉ／Ａｕ工艺在ＰＴＦＥ微波印制电路上的应用，并分析了氨基磺酸盐镀软镍和亚硫酸盐镀软金工艺的影响因素及提高Ｎｉ／Ａｕ镀层之间附着力的措施。通过实验及应用证明了与直接镀金工艺相比，在软基材ＰＴＦＥ敷铜箔板上镀Ｎｉ／Ａｕ工艺能大大提高微波电路的可焊性，高温稳定性和长期可靠性，并且用其所制作的微波器件的高频性能也优于直接镀金工业。     

CMOS电路中抗Latch-up的保护环结构研究

闩锁是CMOS集成电路中的一种寄生效应,这种PNPN结构一旦被触发,从电源到地会产生大电流,导致整个芯片的失效。针对芯片在实际测试中发现的闩锁问题,介绍了闩锁的测试方法,并且利用软件Tsuprem4和Medici模拟整个失效过程,在对2类保护环(多子环/少子环)作用的分析,以及各种保护结构的模拟基础之上,通过对比触发电压和电流,得到一种最优的抗Latch up版图设计方法,通过进一步的流片、测试,解决了芯片中的闩锁失效问题,验证了这种结构的有效性。     

Mobility Influences on the Capacity of Wireless Cellular Networks

Capacity has always been a major concern in wireless networks. This letter studies the impact of mobility on the overall system capacity in wireless cellular networks. In this letter, we present a simple system model which we developed to capture the inherent relationships among system capacity, new call blocking probability, handoff dropping probability, call terminating probability, and bandwidth utilization rate. We investigate the complex relationship between mobility and capacity‐related parameters. Through simulation, we demonstrate that mobility has a significant impact on capacity and is reversely proportional to the bandwidth reserved for handoff traffic.     

医院空调设计的几点体会

空调系统应用于普通房间可能引起空调病 ,应用于医院时此问题将更为突出 ,本文对此类建筑在空调系统设计中应重视的有关问题进行了初步探讨     

内管注水泥固井工具的研究与分析

内管注水泥技术是针对大尺寸套管和表层套管固井的特点及特殊要求而采用的一种固井技术，具有省时、替量少等特点，在现场得到大量推广应用。内管注水泥器是内管固井技术的关键工具，其性能好坏直接影响到固井质量。对各种内管注水泥固井工具的结构及特点分别进行了分析研究，并就其发展方向提出建议。     

铝电解槽磁流体稳定性有限元分析

本文采用有限元法求解分层磁流体小扰动方程系统特征值，研究铝电解槽稳定性。研究结果表明，在没有电磁力时，铝液表面波动（内波）是稳定的。存在电磁力时，它会激发铝液表面波动的某些低频长波分量不稳定性，高频短波不受影响。被激发的不稳定波动频率和扰动增长率与电流密度，磁感应强度垂直分量，铝电解槽长宽比，电解质和铝液的密度差，厚度等因素密切相关。减少电流密度，磁感应强度，增加电极距离和铝液厚度可以提高铝电解槽的稳定性。这对铝电解槽优化设计和在线控制有重要意义。     

Variations in Spectral Slope in Lake Taihu,a Large Subtropical Shallow Lake in China

Spectral slope (S), describing the exponential decrease of the absorption spectrum over a given wavelength range, is an important parameter in the study of of chromophoric dissolved organic matter (CDOM) dynamics, and also an essential input parameter in remote sensing models. Furthermore, S is often used as a proxy for CDOM composition, including the ratio of fulvic to humic acids and molecular weight. The relative broad range in S values reported in the literature can be explained by the different spectral ranges and fitting methods used. A single exponential model is used to fit the S values for 17 investigations involving 458 samples in Lake Taihu from January to October in 2004. The average S value was 15.18 ± 1.39 μm⁻¹ for the range of 280–500 nm, which fell within the range reported in the literature. The frequency distribution of S value basically obeyed a normal distribution. Significant differences in S values between summer and other seasons showed that phytoplankton degradation was one of the important sources of CDOM in summer, whereas CDOM mainly came from the river input in other seasons. Furthermore, the estimated S value decreased with increasing wavelength range used in regression. The maximum and minimum values derived from the regression were 17.89 ± 1.25 μm⁻¹ and 13.62 ± 2.11 μm⁻¹ for the wavelength ranges of 280–380 nm and 400–500 nm, respectively, a decrease of 23.9%. S values significantly decreased with the increase of CDOM absorption coefficients. CDOM absorption coefficients could be more appropriately estimated from exponential model introducing the variation of S with absorption coefficients, making them useful for a remote sensing bio-optical model of Lake Taihu. DOC-specific absorption coefficient a*(λ) and the parameter M describing molecular size of the humic molecules could also be used as a proxy for the sources and types of CDOM. A general relationship was found between S and a*(λ), and M values. S increased with the decrease of DOC-specific absorption coefficient and the increase of M corresponding to the decrease of molecular weight.